Sink Stopper Won T Seal

Water may leak or refuse to drain around a sink pop up for a number of reasons.

Sink stopper won t seal.

The ball rod is inserted into the side of the drain and attached with a nut. It moves the stopper in the opposite direction to the lift rod. Simply remove the plunger clean and if necessary replace. A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod.

Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand. 5 shows the gasket pushed out of position. It s easy to fix a bathroom sink drain plug that s leaking. Click here for maintenance and service parts.

Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain. The gasket located under the stopper may also need to be adjusted. The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper. Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3.

Find replacement parts on amazon. To reach the stopper the ball rod needs to be removed first. A sink stopper mechanism isn t difficult to understand. The clicker may have been over tightened causing the.

The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism. When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece. The ball rod holds the stopper in the drain. This is a repair you can do yourself.

A sink stopper with a push pull rod control at the faucet is a great modern convenience. If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts. Remove stopper from drain. To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain.

The photo on the right fig. How to fix a sink pop up drain stopper. Re tighten the thumb screw by turning clockwise. Fix a sink stopper.

When they do they are often unsightly and an irritation. If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts. Unthread the sink stopper s tailpipe from the underside of the drain. The photo on the left fig.

Remove clip from ball rod. Gasket to push outward.