Both methods require that the floor be sloped 1 4 to 1 2 per foot from perimeters to a drain.
Shower floor floor slopes code.
The answer is no.
If we can slope enough floor space on a bath floor so that the water from a shower runs toward a drain do we need a curb.
To efficiently drain the recommended minimum slope for a shower floor is about 4 percent or a 1 2 inch drop per every 12 inches from the shower walls to the drain.
Curbless shower with linear drain on code requirements.
The issue that we had is that according to the ipc international plumbing code there had to be a dam outside the shower area in order to contain the water.
I bought a totally rehabbed home a few months ago with a huge walk in shower.
Mortar bed and thin bed.
This includes tiling and gradients of bathroom floors including shower recesses.
In traditional tile shower.
There will be a 0 75 drop.
Shower floors slope.
I am planning a bathroom reno that will have a curbless walk in shower 36 x 72 using the usg durock infinity drain shower system.
Tiling in shower recesses.
There is a single drain at the south end but the floor peaks in the middle so half the floor slopes to the drain in the south end but the floor to the north of the middle slopes to the end where there s no drain and water thus pools.
Although not generally required by code it may be appropriate to waterproof areas adjacent to curbless showers.
So slope the floor up from the drain at a minimum of 1 4 per foot or as much as 1 2 per foot then use the 1 2 threshold just before your shower door or other shower opening to get to the 2 above the drain required by plumbing code.
The minimum standard required for wet areas in residential buildings is contained in the building code of australia bca and as3740 waterproofing of wet areas in residential buildings.
Other shower stall configurations shall measure at least 36 inches deep by 60 inches wide 914 mm by 1524 mm with an entrance opening of at least 36 inches 914 mm when a wall is installed on the opening side.